Type 4 billet head
-
-Alex77-
- Posts: 205
- Joined: Sun Feb 10, 2008 12:46 pm
Type 4 billet head
I am currently designing type 4 billet head. Most of the basic design work has been done, but valve-angle bothers me. I must re-measure it again because i am getting more than 10 degrees. I think lower angle would benefit the ports too.
-
Type 4 Unleashed
- Moderator
- Posts: 2202
- Joined: Tue Nov 08, 2005 10:43 pm
Re: Type 4 billet head
I forget if it's 11 or 13 degrees.
Richard
EMW
“Have you ever noticed how some people never
have the money to do it right, but can always
find the money to do it twice ?”
EMW
“Have you ever noticed how some people never
have the money to do it right, but can always
find the money to do it twice ?”
-
Andy Somogyi
- Posts: 64
- Joined: Wed Feb 14, 2018 9:25 am
Re: Type 4 billet head
If you sell them at a reasonable price, and they provide better cooling than stock, I'll be the first in line to buy them.
If you're designing these from scratch, are you also modeling heat-flow?
If you're designing these from scratch, are you also modeling heat-flow?