HVX Breakout

The VW Beetle. Everything about bugs!

Moderator: Marc

Post Reply
bugblanc
Posts: 9
Joined: Thu Dec 28, 2017 7:18 am

HVX Breakout

Post by bugblanc » Mon May 07, 2018 9:32 am

Or at least trying to avoid it when drilling the oil ways.

I have a late Mexican AS41 case and was ready to drill the oilways. However when I got a drill as far as the rear bearing and checked for run out I discovered that it runs out 5mm along the length of the cam and would certainly break out.

The only solution I can see would be to drill at an angle from the bearing oil groove. Playing with angles on the bench this looks like it might just be possible.

I can’t see why this wouldn’t work - has anyone else tried it?

Post Reply