EJ18 in a ‘69 standard

Are you one of those confused people who can't make up their mind?
Post Reply
joelzy
Posts: 93
Joined: Fri Sep 11, 2015 3:53 pm

Re: EJ18 in a ‘69 standard

Post by joelzy » Wed May 09, 2018 8:45 am

pulled the VSS, crank pos, cam pos and IACV to clean and check. No clue if the IACV is working but it is the older version that is adjustable which might come in handy when trying to get the car to idle down more. Unfortunately the gasket is toast after pulling it off this time so i need to find that or perhaps just seal it up with something else. Also, just so we're clear, the IACV for this particular year is like $500 bucks... WTH i paid that much for the entire engine.

Not sure of the best way to test the magnetic sensors with a multimeter as the ohm part isn't reading but i did find a signal and a jump when metal was nearby on each. A potential issue could be the angle I had the VSS aimed. There is a chance it was reading the collar as well as the bolt heads so i am going to test it almost directly head on to the bolts instead to see if it gets a better reading.

Update: I have a VSS reading!! woooo
also made a gasket for the IACV and realized the little cap that i thought was an adjuster of some sort(hard plastic with flat edges to turn it) was actually just a cap someone put on a vac line thats on the IACV so i read elsewhere that it is supposed to be plumbed to the intake pre-maf so i did a low budget version to test soon. car is apart so i cant test fire but once i finish the new VSS bracket and ducting for radiator's fresh air, we should be in good shape.

User avatar
panel
Posts: 3695
Joined: Sun Sep 24, 2000 2:01 am
Location: Victoria B.C. Canada
Contact:

Re: EJ18 in a ‘69 standard

Post by panel » Mon May 14, 2018 12:17 am

Sounds like some good progress !
Subaru JDM EJ20 Turbo bus
Built by Germans powered by Japanese and brought together by Canadians

joelzy
Posts: 93
Joined: Fri Sep 11, 2015 3:53 pm

Re: EJ18 in a ‘69 standard

Post by joelzy » Mon May 14, 2018 11:37 am

trying like hell!

Not sure if i mentioned that i changed air direction once trying the other fan and realizing how much cooler the car ran when pulling the air out of the engine bay but now the air will be scooped from under and forced into the radiator then hopefully out the vents under the window as well as on the decklid. You were right all along Petew :P

Image

radiator shroud is all tacked up and ugly and the scoop is about halfway there. Gotta finish mocking up the scoop, pull out the tig and actually weld everything. Thought later into it that i should have done aluminum but i had a lot of scrap sheet steel and used the existing rad mount in some areas so this made sense. we'll see how well it works once finished but it fits with a couple notches for the iacv and alt cable and it'll be fed by a 4 inch duct that will be getting a lot of air from the scoop under the car.

User avatar
petew
Posts: 3531
Joined: Sat Oct 07, 2006 6:05 pm
Location: Sydney/Australia
Contact:

Re: EJ18 in a ‘69 standard

Post by petew » Wed May 16, 2018 11:29 pm

Looking good. :)

Post Reply