Turbo Buggy

[mads b (dk)]

time will tell if the turbo works or not..... I got if for free

the pipes are 36mm inside and 42.4 outside.....


Tapatalk

[rubenski]

Omg thats some heavy iron

[mads b (dk)]

stainless steel.... but yes it's heavy but I hope it will last long and without cracks

Tapatalk

[mads b (dk)]

I have tried to messure the turbine wheel trim..... it's 47mm inducer and 43mm exducer..... so its not that big

after a lot of searching I found that it's a garrett GTB2056LV

[IMG]//uploads.tapatalk-cdn.com/201705 ... 954933.jpg[/IMG]

Tapatalk

[BlobDK]

Hello Mads

Interesting project, I have tried that as well. I takes quite a long time to finish all the small parts:)
You can see my old engine here: http://buggyforum.dk/viewtopic.php?f=9&t=1056&start=10

Where in Denmark are you located?

[mads b (dk)]

Hello Mads

Interesting project, I have tried that as well. I takes quite a long time to finish all the small parts:)
You can see my old engine here: http://buggyforum.dk/viewtopic.php?f=9&t=1056&start=10

Where in Denmark are you located?

Fredericia

Tapatalk

[mads b (dk)]

I have a old tread on the Danish site buggyforum as well

http://buggyforum.dk/viewtopic.php?f=9&t=1846

Tapatalk

[mads b (dk)]

Test Fitting [IMG]//uploads.tapatalk-cdn.com/201706 ... 4949df.jpg[/IMG]

Sendt fra min SM-G935F med Tapatalk

[BlobDK]

I look forward to see it. It is more fun to see the projects that are special.

[petew]

Test Fitting

Sendt fra min SM-G935F med Tapatalk

Are you sure you want to mount the turbo so close to the fibreglass body? Even with a turbo blanket on it?

[mads b (dk)]

Most fiberglass near the turbo is cut away and replaced by a stainless steel shield.... I'm considering to cut the fiberglass corner near the turbo downpipe[IMG]//uploads.tapatalk-cdn.com/201706 ... 046dc6.jpg[/IMG]

Sendt fra min SM-G935F med Tapatalk


[IMG]//uploads.tapatalk-cdn.com/201706 ... 922a98.jpg[/IMG]

[petew]

Ok, wow. There's a lot more space there than I thought.

With regard to covers. Aluminium will do a better job at moving the heat away from it.

[mads b (dk)]

First test run without turbo actuator, fully open vnt.... nearly no boost..... I hope it helps with the vnt closed [IMG]//uploads.tapatalk-cdn.com/201706 ... ce46ae.jpg[/IMG][IMG]//uploads.tapatalk-cdn.com/201706 ... 1401be.jpg[/IMG]

Sendt fra min SM-G935F med Tapatalk

[mads b (dk)]

Second test run permanent closed vnt..... 1bar boost@4400rpm running pig rich lambda 0.65....

0.2bar@3000rpm

Sendt fra min SM-G935F med Tapatalk

[mads b (dk)]

The buggy is nearly 100% up and running.... regarding turbo size it's making 0.5bar @ 2500 rpm [IMG]//uploads.tapatalk-cdn.com/201707 ... b86900.jpg[/IMG]

Sendt fra min SM-G935F med Tapatalk