3 wires and the ground is going to the relay board. I wired it based off of Mario's wiring guide on his webpage. How should i test the resistance?
Each time i have calibrated it the difference between the closed to wide open has been different. Typically being a 60 count difference. The screenshot shows the closet count difference.
First time turbo build
-
- Posts: 4719
- Joined: Thu Feb 15, 2007 9:28 pm
Re: First time turbo build
Are you sure you have the TPS clocked correctly???
Stripped66 wrote:The point wasn't to argue air temps with the current world record holder, but to dispel the claim that the K03 is wrapped up at 150 HP. It's not.
-
- Posts: 76
- Joined: Thu Apr 27, 2017 1:26 pm
-
- Posts: 76
- Joined: Thu Apr 27, 2017 1:26 pm
Re: First time turbo build
I got a chance to hang out in the garage and tested my tps wires and i think i know why i cant calibrate my tps in tunerstudio. I tested the plug coming from the relay first.
Here is my ground reading Here is my power supply. Just shy of 5 volts And here is the problem... I'm getting a steady follow of .21 volts. From my understanding of what I've read online i should be getting close to 0 volts. What could be causing this?
I didn't get a chance to check my tps position but will definitely make sure it's clocked properly after this fix
Here is my ground reading Here is my power supply. Just shy of 5 volts And here is the problem... I'm getting a steady follow of .21 volts. From my understanding of what I've read online i should be getting close to 0 volts. What could be causing this?
I didn't get a chance to check my tps position but will definitely make sure it's clocked properly after this fix
You do not have the required permissions to view the files attached to this post.