Recently had a Type 3 fan pulley bolt come loose and destroy the bolt.
( apparently there are a lot of mis-published low torque specs for this bolt on Type 3's — everyone lists 35ft/lbs and its actually closer to 90? )
While I'm waiting for a new bolt ( they're getting a bit hard to find NOS) I wanted to order a tap to repair the threads on the crank snout.
Wondering if anyone has/knows the thread specs? 18mm? / 19mm? x 1.5? for the Type 3 Crank pulley(s) bolt?
Who is the best person to rebuild your engine? You...
1 post • Page 1 of 1