Shoptalkforums.com

Finally some quality time in the garage again, and I got a package with new piston rings (I broke one when I disassembled the engine...) so the final assembly could finally begin.

Here's a shot from when I assembled the heads and pushrod tubes: And a couple of the finished longblock: Not too much remaining now before I can put it back in the car; only drawback is that we had another foot of snow yesterday and the car is stored at a friend's barn, so I will need to wait for better weather conditions.

Just caught up on a few pages, wow!

That 3D printer is a dream I bet!

Going back to the restriction thing, I can’t see it being 63mm inlet the issue, my reasoning being if you were sizing a single TB 63mm would be too big from what I gather.... maybe internal turbulence ect?

The new velocity stack design you have is better for flow then the old, there’s a thread fjcamper made I think that compares differnat designs.

Keep up the good work, it’s inspring me to sort my project

http://www.shoptalkforums.com/viewtopic ... 5&t=122047

Hopefully you can get around the photobucket issue

andy198712 wrote: ↑Thu Mar 29, 2018 2:21 am Just caught up on a few pages, wow!

That 3D printer is a dream I bet!

Going back to the restriction thing, I can’t see it being 63mm inlet the issue, my reasoning being if you were sizing a single TB 63mm would be too big from what I gather.... maybe internal turbulence ect?

The new velocity stack design you have is better for flow then the old, there’s a thread fjcamper made I think that compares differnat designs.

Keep up the good work, it’s inspring me to sort my project

Thanks for the input. Glad I can inspire some

Not too much happening in the garage, though; I am wrapping up some plumming and wiring issues, and hopefully the snow will disappear soon so I can get the car back from storage and have the engine installed.

Some updates, I have picked up the car from winter storage and started prepping the engine compartment, and soon this:
will be mated to this: Then I will hopefully be on the road again soon

Looking good!

flat4olsen wrote:Looking good!

Thanks.

And it's in

Greetings from Athens !
Love your work and craftsmanship. Nice to have your boys involved and enjoying quality time with you! I am getting my daughter involved slowly and my youngest son hopefully will follow. Keep up the good work .

E_bug wrote: ↑Tue May 01, 2018 12:00 am Greetings from Athens !
Love your work and craftsmanship. Nice to have your boys involved and enjoying quality time with you! I am getting my daughter involved slowly and my youngest son hopefully will follow. Keep up the good work .

Thanks

Some final prepwork before the accessories are mounted to the engine. I have never used a sewing machine before, so I think I will leave the rest of this to my wife

This will go on the firewall :

My wife took over

nice!

Thanks. Finally i can get on with mounting the rest of the engine

I'm watching. Love the intake filter box build.

Thanks

I had my youngest son helping me today;)