Type 1 DTM accelerator tube

huw'sspeedster · Post by **huw'sspeedster** » Wed Sep 20, 2006 11:42 am

The tube keeps moving in the shroud is there an easy in car fix?is it just a jubillee clip behind the shroud?

Bill K. · Post by **Bill K.** » Fri Sep 22, 2006 2:20 pm

I used a hose clamp to hold a piece of tubing over the accelerator tube on the "front" side of the shroud.

huw'sspeedster · Post by **huw'sspeedster** » Fri Sep 22, 2006 2:26 pm

Thanks Bill I have started with a P clip above the geabox holding on the back of the tinware for now If this holds it will do for the time being the engine should only be in for a couple of months until my Torquer kit arrives and gets built! Need to run the car until then!