Jake - is it possible to remove the adaptor that you have fitted to the back side of the pulley? If so any tips on doing so.
I want to mount a 36-1 wheel onto my Scat DTM pulley. Unfortunately due to the BAS exhaust it can't go on the front of the pulley, so it will need to be fitted to the rear.
I would like to remove the adaptor so I can then machine both it and the pulley to make the adaptor sit further in to then allow a 5mm thick steel disc to be fitted.
Scat DTM pulley
-
- Posts: 20132
- Joined: Fri Jul 07, 2000 12:01 am
Good Luck!
I installed those spacers with a .004 interferance fit using the hot/cold method and they are VERY difficult to remove!
What you might do is machine the thickness of your trigger wheel from the spacer in a lathe. When the trigger is fitted the pulley spacing is corrected and you don't compromise the pulley when doing so.
I installed those spacers with a .004 interferance fit using the hot/cold method and they are VERY difficult to remove!
What you might do is machine the thickness of your trigger wheel from the spacer in a lathe. When the trigger is fitted the pulley spacing is corrected and you don't compromise the pulley when doing so.
-
- Posts: 432
- Joined: Tue Jun 04, 2002 12:01 am
With that much of an interference fit I don't think I have a chance, but it also gives me confidence that I won't have a problem machining some off that spacer.
But whilst looking through the forums I spotted the picture set of the billet pulleys
I'm probably going to tear down the engine over winter, and I think I need to get the flywheel machined - so maybe I need a billet pulley - especially as the timing marks on my pulley are getting a little tired!
Paul
But whilst looking through the forums I spotted the picture set of the billet pulleys
I'm probably going to tear down the engine over winter, and I think I need to get the flywheel machined - so maybe I need a billet pulley - especially as the timing marks on my pulley are getting a little tired!
Paul
-
- Posts: 20132
- Joined: Fri Jul 07, 2000 12:01 am