Page 1 of 1

Type 4 engine parts - updated

Posted: Sat Nov 11, 2017 6:52 pm
by bradey bunch
Hi,

I have the following for sale, send me a PM with your email and I can send photos. Prices in USD, shipping separate.

Everything is new unused, although may show handling marks due to mocking up.

KEP conversion flywheel- $150

Camshaft, 254* @ .050", 112* lobe separation angle - SOLD

Pauter Rods, 136mm length, 22mm pin, type 4 1.7L journal - $500

Type 4 heads, done by brothers machine 42x36mm valves, relocated 12mm plugs, 56cc chambers, dual springs (need to be shimmed to your cam and rocker setup) bored for 94mm jugs - SOLD

Counterweighted 66mm crank done by DPR, .010" under - $250

Pauter 1.48:1 rockers - $500

2 sets of straight cut cam gears - Scat - $75 Magnum - $150

I also have a few type 1 parts I was planning on using for this build, like a 200mm stage 2 kennedy pressure plate, copperhead clutch disc, a bug tech shorty shifter, and 94mm JE pistons with rings, pins, buttons etc listed in the type 1 section.

Braden

Re: Type 4 engine parts

Posted: Sat Nov 11, 2017 7:56 pm
by Piledriver
Are the heads $400 for the pair or each? 1700 castings?

Is the cam a Webcam 163 or something else?

Re: Type 4 engine parts

Posted: Sat Nov 11, 2017 8:19 pm
by _thesatanicmechanic
Following up after Piledriver.

Casting# on the heads?

Web 86a cam? got a pic of the snout?

I'm interested in the cam. need a couple more details plz.

Re: Type 4 engine parts

Posted: Sun Nov 12, 2017 5:32 pm
by bradey bunch
1700 castings from a type 4 if i remember right. For the pair, sold as is. The work was done a few years ago. I have pics of the cam, I need an email address to send to, PM me as per the original post instead of posting it publicly if you'd like.

Braden

Re: Type 4 engine parts

Posted: Mon Nov 13, 2017 2:05 pm
by bradey bunch
Pulled out the spec sheet for the cam and looked at the stampings - Steve Long XR296 cam 254*@ .050", .366" lift.

And the rod specs: C to C length 5.354"
Big end weight: 436g
Overall weight 627g
Small end diameter .8667"
Big end diameter 2.2755"
Big end width 1.015"
Small end width .995"
Material: E4340 Cro mo