36-2 trigger wheel settings

Moderator: Tom Notch

Post Reply
ruff
Posts: 324
Joined: Sun Aug 29, 2004 12:53 pm

36-2 trigger wheel settings

Post by ruff » Sun Apr 02, 2017 3:08 am

hello guys,
changing from 009 to wasted spark..
I will use a 36-2 trigger wheel ( 2 missing teeth are next to each other )
Is the tooth 1 angle still 80 degrees?
I am a bit confused with this weird trigger wheel :)

( I used a 36-1 before and used 80 degrees there )

thanks, Peter

User avatar
Piledriver
Moderator
Posts: 21786
Joined: Sat Feb 16, 2002 3:01 am
Location: Van Alstyne, Texas

Re: 36-2 trigger wheel settings

Post by Piledriver » Sun Apr 02, 2017 1:45 pm

Works the same, still need to verify with timing light.

I'm running a 36-2 ATM in a 009, was supposed to be a 36-1 but had one of the settings wrong on my welder... :roll:
Its a steel spur gear from a gas rc truck.

A 72 tooth will even fit...
72-tooth-in-009.JPG
You do not have the required permissions to view the files attached to this post.
I, for one, regularly embrace our new robot overlords, as I am the guy fixing the robots...

ruff
Posts: 324
Joined: Sun Aug 29, 2004 12:53 pm

Re: 36-2 trigger wheel settings

Post by ruff » Sun Apr 02, 2017 3:32 pm

Piledriver wrote:
Sun Apr 02, 2017 1:45 pm
Works the same, still need to verify with timing light.

I'm running a 36-2 ATM in a 009, was supposed to be a 36-1 but had one of the settings wrong on my welder... :roll:
Its a steel spur gear from a gas rc truck.

A 72 tooth will even fit...72-tooth-in-009.JPG
thanks a lot!
your setup is very nice!
gives my ideas!!

Peter

Post Reply