hello guys,
changing from 009 to wasted spark..
I will use a 36-2 trigger wheel ( 2 missing teeth are next to each other )
Is the tooth 1 angle still 80 degrees?
I am a bit confused with this weird trigger wheel
( I used a 36-1 before and used 80 degrees there )
thanks, Peter
36-2 trigger wheel settings
- Piledriver
- Moderator
- Posts: 22518
- Joined: Sat Feb 16, 2002 12:01 am
Re: 36-2 trigger wheel settings
Works the same, still need to verify with timing light.
I'm running a 36-2 ATM in a 009, was supposed to be a 36-1 but had one of the settings wrong on my welder...
Its a steel spur gear from a gas rc truck.
A 72 tooth will even fit...
I'm running a 36-2 ATM in a 009, was supposed to be a 36-1 but had one of the settings wrong on my welder...
Its a steel spur gear from a gas rc truck.
A 72 tooth will even fit...
You do not have the required permissions to view the files attached to this post.
Addendum to Newtons first law:
zero vehicles on jackstands, square gets a fresh 090 and 1911, cabby gets a blower.
EZ3.6 Vanagon after that.(mounted, needs everything finished) then Creamsicle.
zero vehicles on jackstands, square gets a fresh 090 and 1911, cabby gets a blower.
EZ3.6 Vanagon after that.(mounted, needs everything finished) then Creamsicle.
-
- Posts: 324
- Joined: Sun Aug 29, 2004 10:53 am
Re: 36-2 trigger wheel settings
thanks a lot!Piledriver wrote: ↑Sun Apr 02, 2017 11:45 am Works the same, still need to verify with timing light.
I'm running a 36-2 ATM in a 009, was supposed to be a 36-1 but had one of the settings wrong on my welder...
Its a steel spur gear from a gas rc truck.
A 72 tooth will even fit...72-tooth-in-009.JPG
your setup is very nice!
gives my ideas!!
Peter