Upright parts head tins gen stand

Post Reply
User avatar
dave t
Posts: 421
Joined: Sat Nov 25, 2006 8:43 pm

Upright parts head tins gen stand

Post by dave t » Fri Oct 25, 2019 3:19 pm

Fiberglass head tins. Gen stand. Oil dip stick block for a t-2 case and a crank pulley. 50 pounds of extra aluminum to make more gen stands and oil dipstick blocks.
20191008_170722.jpg
.
You do not have the required permissions to view the files attached to this post.
Last edited by dave t on Mon Oct 28, 2019 4:30 pm, edited 2 times in total.

User avatar
dave t
Posts: 421
Joined: Sat Nov 25, 2006 8:43 pm

Re: Upright parts head tins gen stand

Post by dave t » Fri Oct 25, 2019 3:21 pm

Weird only 1 set not sure why 3 pics showed up.

User avatar
Clatter
Posts: 1826
Joined: Sun Apr 28, 2002 3:01 am

Re: Upright parts head tins gen stand

Post by Clatter » Mon Oct 28, 2019 1:03 pm

$250 for a set to do one conversion?

Or $250 for the whole lot?
What's that Noise??

Beginners' how-to Type 4 build thread ---> viewtopic.php?f=1&t=145853

User avatar
dave t
Posts: 421
Joined: Sat Nov 25, 2006 8:43 pm

Re: Upright parts head tins gen stand

Post by dave t » Mon Oct 28, 2019 4:26 pm

250 for a set to do 1 conversion. Not sure why 3 pics of the same parts showed up. The extra aluminum bits would make more gen stands and dipstick blocks. There is 50 pounds of extra aluminum.

User avatar
dave t
Posts: 421
Joined: Sat Nov 25, 2006 8:43 pm

Re: Upright parts head tins gen stand

Post by dave t » Mon Oct 28, 2019 4:33 pm

50 pounds of extra aluminum for a measly 50.00 plus shipping

User avatar
VIPERGREEN76
Posts: 29
Joined: Sun Nov 02, 2014 11:53 am

Re: Upright parts head tins gen stand

Post by VIPERGREEN76 » Thu Oct 31, 2019 9:52 pm

dave t wrote:
Mon Oct 28, 2019 4:26 pm
250 for a set to do 1 conversion. Not sure why 3 pics of the same parts showed up. The extra aluminum bits would make more gen stands and dipstick blocks. There is 50 pounds of extra aluminum.
Why not put the gen stands & dipstick blocks together, and sell them individually?
76 SEDAN
EC type 4 Conversion project

User avatar
dave t
Posts: 421
Joined: Sat Nov 25, 2006 8:43 pm

Re: Upright parts head tins gen stand

Post by dave t » Fri Nov 01, 2019 6:08 pm

Well a few reasons. I'm lazy. I can't weld aluminum. Everyone wants A DEAL so I would have to pay for them to be welded and no one wants to pay a few dollars less than you can buy them new... oh and I'm lazy.

Post Reply