type 4 turbo 2.0L

[sweetlokin66]

Started on my new beam

[sweetlokin66]

i got it all welded up! Next is fitting the big brakes

[bender]

Look's great Jeremy.....

[sweetlokin66]

Ive been pretty idle lately. Just got back from Costa Rica so now I can spend money on it again . Pistons and Rods are on there way
Gunna have the brake setup hopefully done by this weekend.

[sweetlokin66]

[sweetlokin66]

[sweetlokin66]

[Steve Arndt]

Did you machine the 944 hub to take a bug bearing?

[sweetlokin66]

Its a machined down VW disk brake rotor that was made into a hub . All you gotta do is make a new bracket for the caliper.

[Steve Arndt]

yep, BTDT



I have been trying to get Jaycee to build a run of their hubs with 5x130 and BJ bearings. They sell them for linkpin bearings and Chevy pattern already. I'm like, damn, change two program settings and make a production run!

[sweetlokin66]

[shag55]

yep, BTDT



I have been trying to get Jaycee to build a run of their hubs with 5x130 and BJ bearings. They sell them for linkpin bearings and Chevy pattern already. I'm like, damn, change two program settings and make a production run!

I could get it done but who would actualy buy them. What hubs would be used? It would be nice if I could get the 11" strange hubs in a blank then maybe.

[sweetlokin66]

From EMW. ARP bolts, both ends resized everything looks great.

[sweetlokin66]

[tango]

Are those custom forged pistons? 96mm?

I have some cylinders out being bored for some JE 95mm pistons for my turbo, should be ready soon.

Did you choose a cam yet? 71x96 flat tops with .04 deck and 60cc chambers will give 8.6:1

I am planning to try 8.5:1, with web 119 on 112 lobe centres gives me 6.6:1 and start out with low boost and build up again gradually.