Good morning from Sicily. I am stuck on drilling & tapping the head for the CHT sensor. The instructions call for a 11/32” bit and a 1/8” tap. Is there a metric equivalent to these specs as from my inexperience it would appear that the bit is larger than the tap which does not sound right.
Any assistance would be greatly appreciated.
Request help with installing Quicktune CHT sensor.
-
gdando
- Posts: 111
- Joined: Fri Jun 02, 2006 4:50 am
-
Chip Birks
- Posts: 4043
- Joined: Wed Mar 12, 2008 5:59 pm
Re: Request help with installing Quicktune CHT sensor.
Its 1/8" npt. Bigger than just 1/8"