Motor for a bus

1fasbug · Post by **1fasbug** » Tue Jun 03, 2003 11:00 am

I just ordered the webcam today. They recommended the 163 which is between a engle 110 and 120. I ordered it with 112 lobe seperation. I also got the magnum straight cut gears and web lifters. I will be interesting to see the difference with the lobe seperation.

1fasbug · Post by **1fasbug** » Thu Jun 05, 2003 9:03 am

I ordered weber 44 working with the rule of 4 or 5 mm smaller than the intake valve for a mild engine. I was worried that 40's with the 28mm venturi would have been too small and I wanted some room to move around in case i decide to do something different with the motor later. Can anyone offer suggestions on the jetting based apon these figures:

2007cc
webcam 163
8:1

Thanks for the help

Kiwi · Post by **Kiwi** » Mon Jun 09, 2003 6:01 pm

I also have a bus that will be getting a new engine soon. I was planning on a 2110. I have been reading about these SS pistons and was wondering if I would be able to include them in my build up? Are SS pistons good for a bus? Any advice Jake?