911 6 to VW trans?
-
Max keltvik
- Posts: 240
- Joined: Fri Feb 28, 2003 12:01 am
911 6 to VW trans?
How to bolt a Porsche 2.4l -73 in to a t-1 trans?
-
Piledriver
- Moderator
- Posts: 22880
- Joined: Sat Feb 16, 2002 12:01 am
No idea. Suspect machining on the porsche flywheel would likely be required, or at least the ring gear cut back.
IIRC the TO pad on the PP is in virtually the same place.
(Ring gear really only needs to be 1/4" wide)
Ring gear is std 12v ACVW.
You would have to use a 71> tranny with the guide tube for the TO bearing, or with the press in aftermarket one on the early trannies
The Porsche 901 can be made to fit without too much pain.
Looking for a wild Baja?
IIRC the TO pad on the PP is in virtually the same place.
(Ring gear really only needs to be 1/4" wide)
Ring gear is std 12v ACVW.
You would have to use a 71> tranny with the guide tube for the TO bearing, or with the press in aftermarket one on the early trannies
The Porsche 901 can be made to fit without too much pain.
Looking for a wild Baja?
Addendum to Newtons first law:
zero vehicles on jackstands, square gets a fresh 090 and 1911, cabby gets a blower.
EZ3.6 Vanagon after that.(mounted, needs everything finished) then Creamsicle.
zero vehicles on jackstands, square gets a fresh 090 and 1911, cabby gets a blower.
EZ3.6 Vanagon after that.(mounted, needs everything finished) then Creamsicle.
