Crank/Flywheel roll pin

Dean · Post by **Dean** » Wed Jun 21, 2006 7:33 am

I got my crank after being nitrited. It’s beautiful. The rotating assembly was balanced and I was wondering if I should have a roll pin or just line up the holes when attaching the flywheel.

Thanks

dstar · Post by **dstar** » Wed Jun 21, 2006 7:42 am

Use the rolled-pin.......

Don

MASSIVE TYPE IV · Post by **MASSIVE TYPE IV** » Wed Jun 21, 2006 7:43 am

Dean, the addition of the roll pin will not alter my balance work. It is VERY close to the center of the mass and will have no impact on balance. The nitriding process requires that this pin be removed and they probably forgot to reinstall it. If you want to install one you can buy one at the local hardware store.

Do not hesitate to email us for direct support with questions like this, its what we are here for.

Dean · Post by **Dean** » Wed Jun 21, 2006 8:25 am

Thanks very much!

dstar · Post by **dstar** » Wed Jun 21, 2006 8:44 am

I gotta quit answering questions for Jake, keep fergittin that Qs in THIS forum are usually DIRECTED to Jake.

SORRY Jake! Don't wanna piss ya off inadvertantly!

Don

Passatman · Post by **Passatman** » Wed Jun 21, 2006 10:58 am

How much is it to have a crank nitrated Jake.

MASSIVE TYPE IV · Post by **MASSIVE TYPE IV** » Wed Jun 21, 2006 11:07 am

I only offer the cranks already nitrided, I do not offer the service for customers that have their own crank. The Nitrided cranks are listed on my site.