Page 2 of 2
Posted: Fri Mar 16, 2007 5:22 pm
by Skidmark
Here are pics of the tools I bought to do my wiring harness...
HD crimper and wire stripper - crimper does insulated & non-insulated... they were around $10 each at Orvacs.
Closer image of stripper jaws...
Here is the multimeter I got - kinda high end, probably don't need the true RMS, but Fluke is a good brand. $114 at Sears (used a gift card from Xmas).
Posted: Fri Mar 16, 2007 10:11 pm
by DesertGuy
Seems that the ratcheting crimper is the tool of choice. The Klein model looks like a stout crimper; the cheapest that I found it was $197.00.
As far as strippers go (the wire kind
) I have always used the Ol' School style. What is everyones take on the spring loaded kind... good, bad, indifferent?
And a little off subject, concerning WeatherPack terminals, shrouds, etc... What is the most common size that people that use them grab. I understand that it depends on the circuit, but more times than not do you grab a 3, 4, 6 plug?
Saw this on EBay and made me wonder...
Posted: Sat Mar 17, 2007 1:47 am
by 2088 bob
DG if you can snap those kleins up for $197 grab them they cost me almost $90 bucks more than that here, and i get volume discount from my suppliers but try to buy the exact model pictured you'll see why when you look at them
as far as weatherpack is concerned buy them in a kit with the tool included it will end up running you cheaper in the long run
Posted: Sat Mar 17, 2007 1:42 pm
by Big Dave
I have a Fluke meter very similar to Skids, as well as good crimpers and a wire stripper. The newest tool I got is this
http://buy1.snapon.com/catalog/item_Lg. ... /52470.JPG
It's a hot knife, heat gun, solder iron, blow torch all in one. It heats up very quick and runs for about 20 minutes on as much butane thats in a disposible lighter. Its made by Blue Point and available through Snap On.
