Re: Show me your Single Throttle Body Setup
Posted: Thu Jul 09, 2020 6:16 am
Keep em coming guys
ShopTalk Forums | Aircooled VW Tech & Restoration Help
The aircooled VW tech forum for Beetles, Buses, Karmann Ghias, and Type 3s. Get engine, carb, electrical, and restoration help from experienced VW owners.
https://shoptalkforums.com/
Show me your Single Throttle Body Setup
Page 2 of 2
Re: Show me your Single Throttle Body Setup
Posted: Thu Jul 09, 2020 6:17 am
CB end pieces, wbx TB and home-made induction tubing in stainless steel
Re: Show me your Single Throttle Body Setup
Posted: Thu Jul 09, 2020 7:33 am
Re: Show me your Single Throttle Body Setup
Posted: Fri Jul 10, 2020 5:47 am
It was "out of commision" for a couple of weeks. Back in service now 
Re: Show me your Single Throttle Body Setup
Posted: Wed Jul 15, 2020 9:50 pm
Re: Show me your Single Throttle Body Setup
Posted: Sun Jul 26, 2020 7:42 am
i have the billet throttle body from VWSPEEDSHOP, looks nice and seems well built, i'm happy with it. fancy bits like that are mainly a looks thing!
Re: Show me your Single Throttle Body Setup
Posted: Sun Aug 16, 2020 8:45 am
I’m in the U.K. and use the CB end castings with a custom centre section.
The throttle body comes from a Rover / Honda K-series engine. This one is 48mm, but there is also a larger 52mm variant that was fitted to the series 1 Lotus Elise.
It’s not too tall and has an integrated TPS, which helps with the install.
Only problem is that the throttle pulls in the opposite direction to VW, so had to rig up a small pulley system to get around this.
The throttle body comes from a Rover / Honda K-series engine. This one is 48mm, but there is also a larger 52mm variant that was fitted to the series 1 Lotus Elise.
It’s not too tall and has an integrated TPS, which helps with the install.
Only problem is that the throttle pulls in the opposite direction to VW, so had to rig up a small pulley system to get around this.