Page 1 of 1
Type 1 DTM accelerator tube
Posted: Wed Sep 20, 2006 11:42 am
by huw'sspeedster
The tube keeps moving in the shroud is there an easy in car fix?is it just a jubillee clip behind the shroud?
Posted: Fri Sep 22, 2006 2:20 pm
by Bill K.
I used a hose clamp to hold a piece of tubing over the accelerator tube on the "front" side of the shroud.
Posted: Fri Sep 22, 2006 2:26 pm
by huw'sspeedster
Thanks Bill I have started with a P clip above the geabox holding on the back of the tinware for now If this holds it will do for the time being the engine should only be in for a couple of months until my Torquer kit arrives and gets built! Need to run the car until then!