Looking for the cast flanges for t4 exhaust
-
mojogoat
- Posts: 22
- Joined: Tue Apr 23, 2013 9:58 pm
Looking for the cast flanges for t4 exhaust
Found them before but I can't seem to find the vender for them. Type 4 oval 2 bolt cast iron exhaust header flanges. Anyone see them online?
-
babysnakes
- Posts: 48
- Joined: Sun Jun 05, 2011 7:33 am
-
Piledriver
- Moderator
- Posts: 22775
- Joined: Sat Feb 16, 2002 12:01 am
Re: Looking for the cast flanges for t4 exhaust
Do you mean the head flanges/stubs?
There was a fellow looking at CNCing them a few years ago but I'm not sure he ever grokked there were two patterns needed, he wanted to make one part all the same and just use one pattern... which isn't happening.
There are a few folks who will sell you stubs, and you can make your own in about 30 minutes if you have the fab tools.
There was a fellow looking at CNCing them a few years ago but I'm not sure he ever grokked there were two patterns needed, he wanted to make one part all the same and just use one pattern... which isn't happening.
There are a few folks who will sell you stubs, and you can make your own in about 30 minutes if you have the fab tools.
Addendum to Newtons first law:
zero vehicles on jackstands, square gets a fresh 090 and 1911, cabby gets a blower.
EZ3.6 Vanagon after that.(mounted, needs everything finished) then Creamsicle.
zero vehicles on jackstands, square gets a fresh 090 and 1911, cabby gets a blower.
EZ3.6 Vanagon after that.(mounted, needs everything finished) then Creamsicle.