Page 1 of 1
Distance between engine and flywheel end
Posted: Mon Jul 14, 2014 5:48 pm
by mnakandala
Does any one know the Distance from transaxle locating face of bell housing to clutch disk surface of flywheel?
http://www.thesamba.com/vw/forum/album_ ... id=1231560
Regards
Re: Distance between engine and flywheel end
Posted: Fri Jul 18, 2014 8:22 pm
by panel
Did you get this answered yet?
Re: Distance between engine and flywheel end
Posted: Sun Jul 20, 2014 6:35 am
by mnakandala
panel wrote:Did you get this answered yet?
no sir not yet, at least a VW engine would do
Re: Distance between engine and flywheel end
Posted: Sun Jul 20, 2014 5:13 pm
by sideshow
Based on a sample of two, the X in your picture surface of engine case (same as trans face) 1.434-1.473 to the flywheel teeth/proud surface.
A sample of one, depth of that face to friction surface of flywheel is 1.002
Re: Distance between engine and flywheel end
Posted: Wed Jul 23, 2014 8:09 pm
by mnakandala
Thank you
