1600cc Turbo 1/4 mile results
Posted: Mon Sep 01, 2014 7:10 pm
Last May at BOR I ran my first passes ever in my Turbo 1600dp street bug. heres the specs it had then:
Stock 1600cc DP:
Stock-
Crank
Rods
Pistons
Camshaft
Heads ( except single hi rev springs)
Ignition:
Locked 009 20* timing
Points
autozone coil
autozone plug wires
ngk stock plugs .025 gap
Turbo:
T25 from DSM 2g eclipse
Carb:
holley 350 2bbl
custom intake
custom exhaust
ebay wastegate 5 psi spring
On 10psi heres what it ran:
15.3@90mph
2.3 60 ft
NOW... This time i made some changes and added this only:
MSD BTM
MSD 2 step launch control
MSD Distributor
MSD wires
Snow Performance stg 2 water/meth injection
15 psi wastegate spring
Custom Kafer bar
Oil cooler
100 octane gas
and....18psi of boost
my last pass when I cranked the boost heres my results:
14.1@95mph
2.0 60ft
With better launch i knew i could have reached the 13.99 mark.
every run i improved in the following times:
15.4@90
14.9@92
14.5@92
14.7@93
then 14.1@95
I ran faster then my dial in time on last pass but didnt care when I saw my time. im making a few adjustments and will go back again to get that 13.xx
Stock 1600cc DP:
Stock-
Crank
Rods
Pistons
Camshaft
Heads ( except single hi rev springs)
Ignition:
Locked 009 20* timing
Points
autozone coil
autozone plug wires
ngk stock plugs .025 gap
Turbo:
T25 from DSM 2g eclipse
Carb:
holley 350 2bbl
custom intake
custom exhaust
ebay wastegate 5 psi spring
On 10psi heres what it ran:
15.3@90mph
2.3 60 ft
NOW... This time i made some changes and added this only:
MSD BTM
MSD 2 step launch control
MSD Distributor
MSD wires
Snow Performance stg 2 water/meth injection
15 psi wastegate spring
Custom Kafer bar
Oil cooler
100 octane gas
and....18psi of boost
my last pass when I cranked the boost heres my results:
14.1@95mph
2.0 60ft
With better launch i knew i could have reached the 13.99 mark.
every run i improved in the following times:
15.4@90
14.9@92
14.5@92
14.7@93
then 14.1@95
I ran faster then my dial in time on last pass but didnt care when I saw my time. im making a few adjustments and will go back again to get that 13.xx