Baywindow bus parts-must SELL!!

aerculd · Post by **aerculd** » Fri Oct 24, 2003 10:22 am

Rebuilt 40mm Dells-t1 and t4 manifolds and hexbar linkage.$500.00
T4 1.8 case,crank.rods,flywheel,tin,cooling assembly,lots of duplicates from several engines-$100.00 O>B>O
New WEBCAM cam and lifters model86A-$85.00
003 bus trans -everything works $125.00
Used 74 front beam-straight,no rust-$80.00
T1 singleport engine-ran fine when I parted out the shell-complete down to the muffler,dist,air cleaner-$120.00

I need to make room for my next project!! Located in Allentown PA-
will ship parts-buyer pays shipping.

B.Reiff 610-428-5849 or [email protected]

Stock93 · Post by **Stock93** » Fri Oct 24, 2003 3:17 pm

I'll take the cam and lifters. Does is also have the bolt on cam gear? This is a type IV cam and lifters right?

John

aerculd · Post by **aerculd** » Mon Oct 27, 2003 6:09 am

The cam and lifters have about 50 miles on them-too much duration for a near stock 2.0- I ended up putting a #73 in and like it much better.

I'm busy during the day, prefer calling in the eve. (610)433-4268 Barry

Guest · Post by **Guest** » Fri Oct 31, 2003 8:12 am

The cam is sold.Thanks

MrBreeze.Com · Post by **MrBreeze.Com** » Wed Nov 05, 2003 1:08 pm

I'm looking for the bracket that the clutch cable attaches to at the tranny end for a 77 bus. Let me know if you have one to sell or know where I can order one, mine is about to pop!

Thanks!