pull through intake for DCOE Weber

volksnut · Post by **volksnut** » Tue Jun 26, 2001 6:59 pm

anyone have any luck on building one, I'm fabricating a exhaust and a t section but don't know about the intake...

Muffler Mike · Post by **Muffler Mike** » Wed Jun 27, 2001 7:31 am

I guess the question is can you build one for less then you can buy one? (your time is just as good as money too. At least for me it is.) i think car craft has cast ones listed at $100

------------------
Muffler Mike
www.MufflerMike.com

[This message has been edited by Muffler Mike (edited 06-27-2001).]